A furnace that won't ignite, short-cycles, or keeps tripping its limit switch needs more than a reset in Martell winters. Every visit includes a carbon monoxide safety check, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. We test with real equipment, not parts-cannon guessing.
What doesn't change from visit to visit.
Every repair includes a CO check, not optional.
No-heat calls in Martell get priority routing over routine work during cold snaps when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Both fuel types get the same trained tech, no exceptions.
The most common furnace failure points.
These two parts are behind most no-heat visits, usually a same-visit fix.
We test actual response and pressure output rather than replacing an expensive part on a hunch before we recommend replacing it.
We inspect carefully with proper equipment rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older Martell furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Tell us what the furnace is doing and we'll get someone moving.
A stocked truck arrives ready to diagnose and often repair same visit.
Safety and diagnostic checks come first, then a flat-rate quote.
Most repairs finish same visit, with a final CO check before we leave, backed by warranty.
Recent reviews from winter heating calls.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
Clicking without ignition often points to the ignitor, but we confirm with a resistance test before quoting.
Yes — it can let combustion gases into breathing air, we won't run a confirmed-cracked unit, taken seriously.
A CO check is standard on every call, no upcharge.
Yes — thermocouple and draft-related repairs are covered.
We prioritize no-heat situations even during high demand.
Uncommon parts might mean a follow-up visit to finish the repair.
We dispatch heating techs throughout Martell — call to confirm.
Confirm Coverage
